Lid flavor box (29 mm conveyor) x30 AP.2018 Iame (176)

Why choose the original conveyor 29 mm?

1. Architecture "Fast Flow": The internal profile reduces the load losses, allowing the air-gasoline mixture to reach the valves with optimum speed.

2. Standard competition: Official piece approved for the X30 Senior, Junior and Master categories.

3. Quality Iame: Made in a specific alloy that resists intense vibrations and ensures perfect places to prevent air intakes.

4. Perfect alignment: Designed to work with the 29 mm seal and Tillotson HW-27A carburetor.

? Michel's trick

"The 29 mm conveyor is the highway to your engine! If the interior is scratched or if there is a 'step' between the conveyor and your carburetor, you lose power. My advice: to assembly, check that your 29 mm seal Do not exceed in the conduit. A poorly centered joint that exceeds 1 mm inside, and it's as if you rolled with a flange. For tightening, uses a torque wrench if you can, because if you sail the flange by squeezing too hard, you will never be waterproof again! "

? Mounting Guide

• Sealing: This conveyor requires a seal on each side (carburetor side and flavor box).

• Interview: Check the absence of cracks, especially at the mounting ears, which can undergo constraints with the weight of the air box.

• Compatibility: Exclusively for Iame X30 motors (post-2018) and KA100 evolutions.

✅ Technical characteristics

• Diameter of passage: 29 mm.

• Material: High strength aluminum alloy.

• Year: From 2018.

• Brand: Iame (original room).

Note Magickart: This conveyor is often exposed to the vibrations of the air box. Remember to check the status of your Carburettor gasket 29 mm When installing to leave on a 100% healthy basis.