Complete Exhaust Pipe Kit for IAME X30 SENIOR (post-2018)

Optimize the performance and reliability of your IAME X30 karting engine with this complete exhaust pipe kit.

This genuine IAME part is specifically designed for X30 engines in the configuration SENIOR, for the product models after 2018. It is essential for ensuring a perfect seal and optimal gas flow between the cylinder and the exhaust, thus guaranteeing maximum performance for your kart.

ℹ️ Important note: This complete kit is the official reference for regulatory competition setup on the latest-generation X30 Senior engines. It is a significant improvement over the older versions.

Kit Contents

This kit is delivered ready to assemble and includes all the components necessary for a secure installation:

• Exhaust pipe (x1:) The aluminum cast-iron manifold, precisely machined for a perfect fit on the cylinder’s exhaust port. Its design is optimized for the post-2018 X30 Senior regulations.

• Exhaust studs (x2:) The two threaded set screws that screw into the cylinder to hold the pipe in place.

• Exhaust gaskets (x2:) Two specific gaskets ensuring thermal and gas-tight sealing between the cylinder and the manifold.

• Retaining plate / Spacer (x1:) The perforated plate placed between the nuts and the manifold to distribute the tightening pressure.

Technical Specifications

• Document type: Manifold / Exhaust pipe / Mounting kit.

• Compatibility: IAME X30 engines only.

• Configuration: Specific SENIOR.

• Vintage: For the engines produced after 2018.

• Source: Original IAME Manufacturer (OEM) part.

• Material: High-strength cast aluminum.

• Packaging: Sold as a complete kit.

? Michel's Tip

"Michel, our technical expert, recommends: Tightening the exhaust manifold is critical. Insufficient tightening will cause a gas leak (black marks around the joint), loss of power, and a risk of damage to the gasket or even the manifold. Excessive tightening could crack the manifold or damage the thread in the cylinder.For optimal installation, use locknuts (Nyloc type) or exhaust-specific copper nuts to prevent them from loosening due to vibrations. Tighten the two nuts alternately and progressively to the recommended torque (generally between 1.5 and 2.0 m.kg, to be checked according to your wrench. Remember to check the tightness after the first few minutes of riding.

⚠️ Safety advice: The exhaust is a part that becomes extremely hot. Always handle the pipe with protective gloves after a track session. Do not use unspecified jointing paste for exhaust systems, this could clog the duct or damage the motor.

Order your exhaust pipe kit Iame X30 from 2018 onwards on Magickart.fr for guaranteed performance. Fast shipping.

? Product Information (GPSR) & Technical Summary